Mitox CS50 Manuale dell'Operatore Scaricare il pdf (Pagina 17)

CS45 / CS50 / CS56 Chainsaw

Original Instructions Version April 12

Hot engine

1. Set the switch (3) to “I” position.

2. Pull out the choke knob (5), then push the choke knob back in, this will set the throttle to the hot

start position.

3. Push in the decompressor valve (6).

4. Apply the chain brake by pushing the front hand guard (7) forwards.

5. Pull the starter handle until the engine runs.

6. As soon as the engine is running, pull the throttle lever slightly to reset the throttle control to idle.

This must be done as soon as the engine has started to avoid unneccessary wear on the clutch.

NOTE: Disengage the chain brake by pulling the front hand guard towards the front

handle prior to cutting.

Running In

During the rst ten hours of work, avoid running the engine at maximum speed for a prolonged period until

all the components have bedded in. After the engine has been run in, it will reach its maximum power.

After two hours of work, check that all nuts and screws are securely fastened and tighten if necessary.

Stopping Engine

1. Release the throttle lever and allow the engine to run at idle for half a minute.

2. Shift the ignition switch to the STOP position (“0”).

NOTE: Except for an emergency, avoid stopping the engine while at full throttle.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 47 48

Nessun commento

Mitox CS50 Manuale dell'Operatore Pagina 17